Table tennis bats are made up of two parts, the blade and the rubber. The rubber is the most important part of the bat as it provides the surface that the ball is bounced off of. It is important to keep the rubber in good condition, as this will determine how much control and speed you have when playing. However, sometimes the rubber can become damaged or worn and needs to be replaced. This guide will explain how to properly remove the rubber from a table tennis bat.

Replacing the rubber on a table tennis bat is not difficult, but it is important to take the necessary precautions to ensure that the blade is not damaged. With the right tools and a bit of patience, you can have your table tennis bat good as new in no time. It is important to make sure you use the right glue and cut the rubber to the correct size before attaching it to the blade.
You’ll need a pair of scissors, a table tennis blade, a rubber cleaner, a rubber sheet, and a rubber glue. Additionally, if you’re using a pre-made rubber sheet, you may also need a rubber sponge, a rubber scraper, and a rubber clamp. All of these tools can be found in most sporting goods stores.
Step 1: Prepare the Bat
Before you can remove the rubber from a table tennis bat, it is important to prepare the bat for the process. Start by laying the bat on a flat surface and use a screwdriver to unscrew the handle from the blade. This will allow for easier access to the rubber and will make the process of removing the rubber much smoother.
Step 2: Cut the Rubber
Once the handle has been removed from the blade, use a sharp knife or scissors to cut the rubber away from the blade. Make sure you cut all the way through the rubber and don’t leave any pieces attached.
Step 3: Peel Off the Rubber
Once the rubber has been cut away from the blade, use your fingers or a pair of tweezers to peel off the rubber. Make sure you are gentle and don’t pull too hard, as this could damage the blade.
Step 4: Clean the Blade
Once the rubber has been completely removed, use a soft cloth to clean the blade of the bat. Make sure to remove any sticky residue left behind by the rubber.
Step 5: Attach the New Rubber
Once the blade has been cleaned, it’s time to attach the new rubber. Start by cutting the new rubber to the same size as the old one. Then, use a glue specially designed for table tennis bats to attach the rubber to the blade. Make sure to follow the instructions on the glue carefully, as improper application could damage the rubber and the blade.
Removing the rubber from a table tennis bat is a relatively simple process, but it is important to take the necessary precautions to ensure that the blade is not damaged. With the right tools and a bit of patience, you can have your table tennis bat good as new in no time.
Leave a Reply